Kyocera ECOSYS M2535dn - Adjusting Density

5
5-11
Sending Functions
Adjusting Density
Use the procedure below to adjust the density when scanning the originals.
The procedure for adjusting the density is explained below.
1 Press the Send key.
2 Place the original.
3 Press the Function Menu key. Function Menu appears.
4 Press the  or  key to select [Density].
5 Press the OK key. Density appears.
6 Press the  or  key to select your desired density.
7 Press the OK key.
Completed. is displayed and the screen returns to the
basic screen for sending.
8 Specify the destination, and press the Start key to start
sending.
NOTE: Press the Reset key to reset the settings selected in
Function Menu.
Function Menu: a b
*********************
2 Original Size T
3
Original Image T
[ Exit ]
1 Color Selection T
Density: a b
4 w Lighter -1
*********************
6 z Darker +1
5 y Normal 0