2
Preparation before Use
2-51
3
Adjust the position of the paper guides on the MP tray.
Standard paper sizes are marked on the MP tray or
Manual Feed tray. For standard paper sizes, slide the
paper guides to the corresponding mark.
4
Align the paper with the paper guides and insert as far as
it will go.
IMPORTANT:
Keep the side that was closest the package
seal facing up.
Curled paper must be uncurled before use.
Straighten the top edge if it is curled.
When loading paper into the multi purpose tray, check that
there is no paper left over in the tray from a previous job
before loading the paper. If there is just a small amount of
paper left over in the multi purpose tray and you want to add
more, first remove the left-over paper from the tray and
include it with the new paper before loading the paper back
into the tray.
Loading Envelopes
1 envelope may be loaded in the multi purpose tray.
Acceptable envelope sizes are as follows.
Acceptable Envelope Size
Hagaki 100 × 148 (mm)
Oufuku Hagaki 148 × 200 (mm)
Youkei 2 114 × 162 (mm)
Youkei 4 105 × 235 (mm)
Monarch 3 7/8" × 7 1/2"
Envelope #10 (Commercial #10) 4 1/8" × 9 1/2"
Envelope DL 110 × 220 (mm)
Envelope C5 162 × 229 (mm)
Executive 7 1/4" × 10 1/2"
Envelope #9 (Commercial #9) 3 7/8" × 8 7/8"
Envelope #6 (Commercial #6 3/4) 3 5/8" × 6 1/2"
To Next Page
Loading...
