OPERATION GUIDE 2-1
2 Preparing to FAX
Setting the Current Date and Time (Date & Time Setting)
Set the date and time of the built-in clock. Confirm that the date and time set here
are correct (they will serve as the basis for all scheduled transmissions).
IMPORTANT: Battery used for the built-in clock is rechargeable. Do not turn off the
machine immediately after setting the date and time. Keep it being turned on for
approximately 2 hours until charging is completed.
Periodically check the time that is shown in the message display and adjust as
necessary to match the current time.
1 Access 41.Date/Time.
If you are unsure how to use this route map refer to Accessing Menu Items on
page xii.
2 Enter the current date and time using the numeric keys and press [OK]. The
display returns to the ready screen.
Date and Time Configuration
NOTE: Set the time on 24-hour configuration.
[Menu]
W or X
4.Fax Setup
[OK]
W or X
41.Date/Time
[OK]
Destination On Date & Time
setting screen
On Information/
Report
Note
USA/Canada ’YY-MM-DD hh:mm MM/DD/YYYY hh:mm Y: year, M:
month, D: day,
h: hour, m:
minute
Europe DD/MM/YYYY hh:mm
Others YYYY/MM/DD hh:mm
To Next Page
Loading...
