FAX Operation (Basic)
3-2 OPERATION GUIDE
Automatic Send
General transmission using the numeric keys is explained.
Switching to the Send Screen
1 Press the FAX key. Check that the basic send
screen is displayed.
NOTE: Depending on the settings, the Address Book
screen may appear. In this event, press Reset to
display the basic screen for sending.
Selection of Transmission Method
2 There are two transmission methods - memory
transmission and direct transmission. The default is
memory transmission.
To select direct transmission, use the following
procedure.
1 Press the Function Menu key.
2 Press the U or V key to select [FAX Direct
TX].
3 Press the OK key.
4 Press the U or V key to select [On].
5 Press the OK key.
NOTE: In direct transmission, you can designate only
one destination for one transmission.
Setting for Direct
transmission
Description
Off Starts memory transmission.
After originals are scanned into memory, the communication starts.
On Starts direct transmission.
Dials the receiving system, and after the communication has
started, originals are scanned.
To Next Page
Loading...
