FAX Operation (Basic)
3-6 OPERATION GUIDE
Selecting the Resolution
5 Select the resolution suitable for sending originals.
•200 × 100 dpi (Normal): when sending originals
with standard size characters
Typical character size: 10.5 point (example:
Resolution Resolution)
•200 × 200 dpi (Fine): when sending originals with
relatively small characters and thin lines
Typical character size: 8 point (example:
Resolution Resolution)
•200 × 400 dpi (Super Fine): when sending
originals with minute characters and lines
Typical character size: 6 point (example:
Resolution
Resolution)
•400 × 400 dpi (Ultra Fine): when sending originals
with minute characters and lines more finely
Typical character size: 6 point (example:
Resolution
Resolution)
NOTE: The default setting is 200 × 100 dpi (Normal).
The higher the resolution, the clearer the image.
However, higher resolution also means longer send
times. Normally, up to 400 × 400 dpi (Ultra Fine) is
recommended.
The machine does not support resolution of 300 × 300
dpi when sending faxes. If you have selected 300 × 300
dpi, the machine sends faxes after lowering the
resolution to 200 × 200 dpi (Fine).
The scan resolution should be equal to or higher than
the fax resolution. If the selected resolutions are not in
this condition, the machine automatically adjusts the
resolution and changes the selection.
1 Press the Function Menu key.
2 Press the U or V key to select [FAX
Resolution].
3 Press the OK key.
4 Press the U or V key to select the desired
resolution.
5 Press the OK key.
To Next Page
Loading...
