4-103
Operation Panel
5 Press U or V to select whether Thin Print is enabled.
6 Press [OK]. The Thin Print is set and the ThinPrint menu
reappears.
When Thin Print is set to On, the settings for Thin Print over SSL
are displayed, so continue on and set these.
7 Press U or V to select ThinPrintOverSSL.
8 Press [OK]. The ThinPrintOverSSL screen appears.
9 Press U or V to select whether Thin Print over SSL is enabled.
10Press [OK]. The Thin Print is set and the ThinPrint menu
reappears.
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used. The default setting is Auto.
1 In the Network Security menu, press U or V to select LAN Interface.
2 Press [OK]. The LAN Interface screen appears.
The available LAN Interfaces are as follows:
Auto
10Base-Half
10Base-Full
100Base-Half
100Base-Full
1000Base-T
3 Press U or V to select the desired LAN Interface.
4 Press [OK]. The LAN Interface is set and the Network Security
menu reappears.
I/F Block Set. (External interface block setting)
You can use this to block and thereby protect the interface.
The options available in I/F Block Set. are as follows:
• USB Host (USB Port setting)...4-104
• USB Device (USB interface setting)...4-104
• Option I/F (Optional network interface setting)...4-104
• Parallel I/F (Parallel interface setting)...4-105
• USB Storage (USB memory setting)...4-105
1 In the Security menu, press U or V to select I/F Block Set..
To Next Page
Loading...
Need help?
General
