2-25
Preparation before Use
Loading Paper into the MP (Multi-Purpose) Tray
The multi purpose tray will hold up to 100 sheets of A4 or smaller plain paper (80 g/m²).
The multi purpose tray accepts paper sizes from A4 to A6 and Hagaki and from Legal to Statement, 216 × 340 mm,
Envelope Monarch, Envelope #10, Envelope DL, Envelope C5, Executive, Envelope #9, Envelope #6, ISO B5, Oufuku
Hagaki, Oficio II, 16K, Folio, Youkei 2, Youkei 4 and Custom. Be sure to use the multi purpose tray when you print on any
special paper.
The capacity of the multi purpose tray is as follows.
• A4 or smaller plain paper (80 g/m²): 100 sheets
• Hagaki: 1 sheet
• OHP film: 1 sheet
• Envelope DL, Envelope C5, Envelope #10 (Commercial #10), Monarch, Youkei 4, Youkei 2: 5 sheets
• Folio: 20 sheets
• Thick paper: 5 sheets
1 Fan the media (paper/transparencies), then tap it on a level surface
to avoid media jams or skewed printing.
2 Pull the MP tray towards you until it stops.
IMPORTANT When using media types other than plain paper (such as recycled or colored paper), always specify
the media type setting. (Refer to Media Type (Paper type setting for the MP tray) on page 4-27.) If you are using a
paper weight of 106 g/m² or more, set the media type to Thick.
Note When you use special paper such as transparencies or thick paper, select the media type by referring to
Media Type (Paper type setting for the MP tray) on page 4-27.
To Next Page
Loading...
Need help?
General
