Kyocera KM-1500 - Page 34

2DC-2
1-4-2
General
Initialization
Drive, paper
feed and paper
conveying
system
Optical
High voltage
Developing
U000 Outputting an own-status report —
U001 Exiting the maintenance mode —
U004 Checking the machine number —
U005 Copying without paper —
U019 Displaying the ROM version —
U020 Initializing all data —
U021 Initializing memories —
U030 Checking motor operation —
U031 Checking sensors for paper conveying —
U032 Checking clutch operation —
U034 Adjusting the print start timing
• Adjusting the leading edge registration 0.8
• Adjusting the center line 0
U051 Adjusting the amount of slack in the paper
•Drawer 0
• Bypass tray 0
• Optional drawer 0
U060 Adjusting the scanner input properties 12
U063 Adjusting the shading position 0
U065 Adjusting the scanner magnification
• Main scanning direction 0
• auxiliary scanning direction 0
U066 Adjusting the leading edge registration for scanning an original on the 0
contact glass
U067 Adjusting the center line for scanning an original on the contact glass 7
U070 Adjusting the DP magnification -8
U071 Adjusting the DP scanning timing
• Adjusting leading edge registration 12
• Adjusting trailing edge registration 0
U072 Adjusting the DP center line 2.7
U073 Checking scanner operation —
U074 Adjusting the DP input light luminosity 1
U087 Turning the DP scanning position adjust mode on/off
• Setting the mode on/off On
• Setting the reference data for identifying dust 35
U088 Setting the input filter (moiré reduction mode) Off
U089 Outputting a MIP-PG pattern —
U091 Checking shading —
U092 Adjusting the scanner automatically —
U093 Setting the exposure density gradient
• Text/text and photo/photo mode 0
U100 Setting the main high voltage —
U101 Setting the other high voltages
• Developing bias clock frequency 26
• Developing bias clock duty 55
• Transfer charging output OFF timing 48
• Transfer charging output ON timing 45
U144 Setting toner loading operation 0
U157 Checking/clearing the developing drive time —
U158 Checking/clearing the developing count —
* Initial setting for executing maintenance item U020
Section
Item
Maintenance item contents
Initial
No. setting*
(2) Maintenance mode item list