Kyocera KM-1650

2DA/2DB
1-3-25
Transfer unit
TP bind screw
M3 x 06
Pin
Attach the transfer unit.
9. Insert the transfer unit from the MFP front
side and slide it to the left to install to the
ejection part.
10. Place the transfer unit closer to the ejection
side and then secure the front side using the
TP bind screw M3 x 06 and the rear side
using the pin.
Figure 1-3-43
Release the lever securing fitting.
11. Loosen the screw located at the rear side of
the transfer unit and release the lever secur-
ing fitting in the direction of an arrow, and
then retighten the screw.
Figure 1-3-44
Screw
Lever
securing fitting