2DA/2DB
1-3-26
Attach the intermediate tray.
12. Loosen the screw located inside of the MFP
by about 3 turns.
* Do not turn the screw too much, otherwise
it may drop in the machine.
13. Hang the hook of the hook holder onto the
screw and then retighten the screw.
Figure 1-3-45
14. Insert the intermediate tray from the front
side of the MFP while pushing the hook to
the back and then push the pin located at
the right rear side of the intermediate tray
into the hook holder until the fitting sound is
heard.
Figure 1-3-46
Screw
Screw
Screw
3
Hook holder
Hook holder
Intermediate
tray
Hook
Pin
Hook
holder
To Next Page
Loading...
