Kyocera KM-1650

2DA/2DB
1-3-36
Remove the shield cover.
7. Remove the six screws, lift the shield cover
and then remove the cover.
Figure 1-3-67
Remove the modular cover.
8. Remove the screw and take off the modular
cover.
Figure 1-3-68
Attach the fax control PCB assembly.
9. Loosen the screw on the printer board.
10. While taking care that the mounting surface
of the board does not contact the frame sec-
tion of the rear cover, insert the U terminal of
the ground wire of the fax control PCB
assembly and secure it with the screw.
Figure 1-3-69
Screws
Screws
Shield cover
Screw
Modular cover
Fax control PCB assembly
Screw
Ground wire
Frame section