System Menu
7-9
Selecting Sorting and Offsetting Output
Set sorting and offsetting output options in default settings mode. The setting items are as follows.
For further details about sort mode, refer to Operation Guide; for further details about offset mode,
refer to page 1-9.
1
Referring to Accessing the Copy Default screen on page 7-2, access the Copy Default screen.
2
Press [S] or [T] to select Sort/Offset (Sort/Group) and press [Change #].
3
Under Sort, select [Off] ([Sort:Off]) or [On] ([Sort:on]).
4
Under Offset, select [Off] or [On] ([1 set] or [Output each page]).
5
Press [Close] to save settings or [Back] to cancel settings. The display returns to the Copy Default
screen.
Selecting Auto Rotation
Set auto rotation in default settings mode. The setting items are as follows.
For further details about auto rotation, refer to page 1-41.
1
Referring to Accessing the Copy Default screen on page 7-2, access the Copy Default screen.
2
Press [S] or [T] to select Auto Rotation and press [Change #].
3
Select [Rotate] or [No Rotate].
4
Press [Close] to save settings or [Back] to cancel settings. The display returns to the Copy Default
screen.
Setting Margin Defaults
Set the margin width default values. The setting ranges are as follows.
For further details about margin mode, refer to page 1-17.
1
Referring to Accessing the Copy Default screen on page 7-2, access the Copy Default screen.
2
Press [S] or [T] to select Default margin width and press [Change #].
Item Description
Sort Off (Sort:Off) Do not enable sort mode.
On (Sort:on) Enable sort mode.
Offset Off Do not enable offset mode.
On (1 set or Output each
page)
Enable offset mode. (When set to [Sort:Off], defaults to
[Output each page] with metric models)
Item Description
No Rotate Do not enable auto rotation.
Rotate Enable auto rotation.
Model Type Range
Inch models 0
- 3/4" (1/8" increments)
Metric models
0 - 18 mm (1 mm increments)
To Next Page
Loading...
Need help?
General
