Job Accounting
6-4 OPERATION GUIDE
Department ID Code Registration
A Department ID Code of up to 8 digits can be entered.
1 Display Job Accounting. (Refer to Job Accounting
Operation Procedures on page 6-3.)
2 Press or to select display 02.Register
code, and then press the OK key.
3 Enter the Department ID Code to be registered (up
to a maximum of 8 digits) using numeric keys.
NOTE: Number from 0 to 99999999 can be entered.
If a mistake is made during input it can be cleared by
pressing the Stop/Clear key and the value reentered.
4 Press the OK key.
The code that was input will flash on and off.
5 After confirming the code that was entered, press
the OK key.
The display will return to that of Step 2.
NOTE: If an existing Department ID Code is attempted
to be registered, an error will occur and Already
registered. will display in the message display. In this
case, register a different Department ID Code.
To Next Page
Loading...
