Copying Functions
OPERATION GUIDE 4-17
4
Margin Mode
Shift the original image to make space on the copy for binding on the left (right) or top (bottom) side.
The following margin widths are available.
NOTE: If the left width of the Binding Margin is set when setting the 2-Sided Copy, the right side of the Binding
Margin will be set automatically for the reverse side by the 2-sided copy rotational setting in the case where it is
not rotated.
Use the procedure below to make copies with margins.
1 Place the originals on the platen.
IMPORTANT: Place the original so that the side to be
set for the Margin shift is on the right side (on the left
side, in the case of the optional Document Processor)
and check its position after setting it. If the original is
placed in the wrong direction, the Binding Margin will
not be produced in the position set.
NOTE: The Binding Margin can also be set in the
System Menu. (Refer to Setting the Margin on page 4-
9.)
he value set in the System Menu will inherit the value
that is set at the time when the copy is made.
2 Press the Margin key.
The Margin indicator will light up.
Input units Margin Width
Inch Models 0.13 to 0.75" (in 0.12" increments)
Metric Models 1 to 18 mm (in 1 mm increments)
To Next Page
Loading...
