Kyocera TASKalfa 180 - Density Steps; Initial Density

System Menu
5-10 OPERATION GUIDE
3 Press or to select Text+Ph Dens, Photo
Density or Text Density, and then press the
OK key.
The display will return to that of Step 2.
Initial Density
Sets the copy density at the time the copier is turned on to Manual or Automatic.
1 Display the System Menu. (Refer to System Menu
Operation Procedures on page 5-7.)
2 Press or to select select 04.Initial
Dens
, and then press the OK key.
3 Press or to select Manual or Auto, and
then press the OK key.
The display will return to that of Step 2.
EcoPrint
Selects the initial value of EcoPrint when the power is turned on. The initial value of the EcoPrint can also be
set to on (Enable).
1 Display the System Menu. (Refer to System Menu
Operation Procedures on page 5-7.)
2 Press or to select select 05.EcoPrint , and
then press the OK key.
3 When EcoPrint is to be used as the initial value,
press
or select to On (Enable), and then
press the OK key.
The display will return to that of Step 2.
Density Steps
Changes the number of steps for the copy's density.
1 Display the System Menu. (Refer to System Menu
Operation Procedures on page 5-7.)
2 Press or to select select 06.Density
steps , and then press the OK key.
System Menu:
04.Initial Dens
System Menu:
05.EcoPrint
System Menu:
06.Density steps