Troubleshooting
OPERATION GUIDE 8-7
8
The waste toner box is full. Replace it with a new waste
toner box.
7-9
250 copies have been stored on output tray. Remove
the paper, press the Start key and resume copying.
—
Originals were set in the optional Document Processor
when copying on 2-sides (front and back sides), when
copying from the platen in 2-Sided copy, 2 in 1, 4 in 1 or
when collating copies. Remove the originals from the
Document Processor, replace the originals on the
Original Table after exiting the front and back copying, 2-
Sided copy, 2 in 1, 4 in 1 or Collate Mode and resume
copying.
—
If the optional Document Processor is being used, there
are originals left on the original table. Remove the
originals, return them to the original table and try
copying them again.
—
Check the paper cassette that corresponds to the
lighting indicator. Set the cassette.
2-4
Tap and shake the new toner container without spilling
the toner, and install it again.
7-9
The Toner Container has not been set. Set the Toner
Container.
7-9
The Add Toner indicator blinks on
and off.
There is very little toner remaining. Copying can be
continued for a short while before running out of toner.
Prepare the toner container.
7-9
The Periodic Maintenance
indicator blinks on and off.
This is a notification that the time for periodic
maintenance is approaching.
—
The Periodic Maintenance
indicator lights up.
It is time for Periodic Maintenance. Contact your service
representative.
—
“= = =” appears on the copy
quantity display.
Job Accounting being set. Use the numeric keys to enter
the assigned Section Code to perform copying
operations. Press the Logout key after copying is
finished to display “= = =” again.
6-9
Display Corrective Procedure
Reference
Page
To Next Page
Loading...
