Copying Functions
OPERATION GUIDE 4-15
4
Types of Page Boundary Lines
The following types of the boundary lines are available.
The procedure for using Combine mode copying is explained below.
1 Place the originals on the platen.
NOTE: The underside Rotate Copy can also be set in
the System Menu. (Refer to 2-Sided Copy Reverse
Side Rotation Setting on page 4-5.)
The value set in the System Menu will inherit the value
that is set at the time when the copy is made.
2 Press the Combine key to light up the or
indicator.
3 Enter the number of sets of copies using the
numeric keys.
4 Press the Start key to start scanning.
If the originals have been set in the optional
document processor, copying starts automatically.
If the original has been set on the platen, a
message prompting replacement of the original is
displayed. In this case, proceed to the next step.
5 Replace the original and press the Start key.
Scanning of the original is performed.
6 After scanning all originals, press the OK key to
start copying.
4 in 1 Layout Order
Follow the procedure below to change the order in which pages are to be laid out within the copied page when
making 4 in 1 copies.
To Next Page
Loading...
