Copying Functions
OPERATION GUIDE 4-13
4
Output Destination
You can use the procedure below to select an output destination such as the optional document finisher for your
copies.
NOTE: Optional output destinations include the job separator, document finisher, 3,000 sheet document
finisher and mailbox.
The table below shows the available output destinations.
NOTE: To change default destination for copies, refer to Paper Output on page 8-17 for details.
Use the procedure below to select the output destination.
1 Press the Copy key.
2 Place the originals on the platen.
3 Press [Org./Paper/Finishing] and then [Paper
Output].
4 Select the output destination for finished copies.
When you select [Finisher Tray], [TrayB], [TrayC] or
[Tray1] to [Tray7], select the orientation of output
copy, Face Up (print facing up) or Face Down (print
facing down).
5 Press [OK].
6 Press the Start key to start copying.
Destination Description
Top tray Top tray of the machine (where copies are stored)
Finisher Tray*
* Copy output orientation can be selected either as face-up (print facing up)
or face-down (print facing down).
Tray of the optional document finisher
TrayA,TrayB*,TrayC* Trays A to C in the optional 3,000 sheet document
finisher
Job Separator Tray Optional job separator
Tray1 to 7* Trays 1 to 7 in the optional mailbox (tray 1 is the top
tray)
To Next Page
Loading...
