Default Setting (System Menu)
OPERATION GUIDE 8-55
8
Send/Box Density Adjust
Adjust scan density when sending or storing the data in Document Box. Adjustment can be made in 7 levels
both in auto and manual density modes.
1 Press the System Menu key.
2 Press [ ], [Adjustment/Maintenance] and [Next] of
Send/Box Density Adjust..
3 Press [Change] of Auto or of Manual.
4 Press [-3] - [+3] (Lighter-Darker) to adjust density.
5 Press [OK].
Drum Refresh
Refresh the drum when image blur or white spots appear on images in copies.
CAUTION: Drum Refresh cannot be performed while printing. Execute Drum Refresh after the printing is done.
Use the procedure below to refresh the drum.
1 Press the System Menu key.
2 Press [ ], [Adjustment/Maintenance].
3 Press [Next] of Drum Refresh.
4 Press [Execute] to Drum Refresh.
5 After Drum Refresh is completed, press [OK] to
return to the Adjustment/Maintenance screen.
Correcting Fine Black Lines
Correct fine black lines (black streaks caused by contamination), which may appear on the copies, when the
optional document processor used.
To Next Page
Loading...
