Preparation before Use
2-28 OPERATION GUIDE
Loading Originals
Follow the steps below to load originals for copying, sending or storing.
Placing Originals on the Platen
You may place books or magazines on the platen in addition to ordinary sheet originals.
1 Open the original cover.
NOTE: If the optional document processor is installed,
open the document processor. Before opening the
document processor, be sure that there are no originals
left on the original table or on the original eject table.
Originals left on the original table or on the original
eject table may fall off when the document processor is
opened.
Keep the document processor open if the original is
40 mm or thicker.
2 Place the original. Put the scanning side facedown
and align it flush against the original size indicator
plates with the back left corner as the reference
point.
To Next Page
Loading...
