Management
11-20 OPERATION GUIDE
Applying Limit of Restriction
This specifies how the machine behaves when the counter has reached the limit of restriction. The table below
describes the action taken.
Use the procedure below to apply the restriction limit.
1 Press the System Menu key.
2 Press [User Login/Job Accounting].
3 If user login administration is disabled, the user
authentication screen appears. Enter your login
user name and password and then press [Login].
For this, you need to login with administrator
privileges. Refer to Adding a User on page 11-5 for
the default login user name and password.
4 Press [Next] of Job Accounting Setting, [Next] of
Default Setting and then [Change] of Apply Limit.
5 Select [Immediately], [Subsequently], or [Alert
Only].
6 Press [OK].
Item Description
Immediately *
* The next job will be prohibited in sending or in storing in the box.
Job stops when the counter reaches its limit.
Subsequently Printing/scanning of the job continues but the subsequent job
will be rejected.
Alert Only Job continues while displaying an alert message.
To Next Page
Loading...
