Kyocera TASKalfa 420i - U163 Resetting the fuser problem data; U167 Checking;clearing the fuser counts; U196 Turning the fuser heater on

Basic Operation
3-18 OPERATION GUIDE
Use the procedure below to produce stapled copies.
1 Press the Copy key.
2 Place the originals on the platen.
3 Press [Org./Paper/Finishing] and then [Staple/
Punch].
4 Select the staple position.
NOTE: To use saddle stitching, press [Bind and Fold].
When placing originals, be sure to place the cover
page at the bottom. For more information on saddle
stitching, refer to Booklet from Sheets on page 4-19.
5 Press [Original Orientation] to choose orientation of
the originals, either [Top Edge Top] or [Top Edge
Left]. Then press [OK].
6 Press [OK].
7 Press the Start key. Copying begins.
Built-in Finisher
Cassette Paper Load
Direction
Built-in Finisher
Cassette Paper Load
Direction
Original Orientation:
Top Edge (Back Edge)
Original Orientation:
Top Edge (Back Edge)
Original Orientation:
Left Top Edge (Left top
corner)
Original Orientation:
Left Top Edge (Left top
corner)
Staple/Punch
Top
Right
Staple
Top
Left
2 staples
Top
2 staples
Right
Ready to copy.
Copies
Status
08/08/2009 10:10
Cancel OKAdd Shortcut
Preview
Original
Zoom
Paper
100%
---
:
:
:
---
Place original.
Top Edge Top
Original
Orientation
Punch
Off
Off
Bind
and Fold
2 staples
Left
2 holes
Top
2 holes
Left
3 holes
Left
3 holes
Top
3 holes
Right
2 holes
Right