Kyocera TASKalfa 650c

2 HOW TO MAKE COPIES
48 Bypass Copying
 Bypass copying on non-standard size paper
1
Place the original on the original glass.
y The height of the paper must not exceed an indicator on the side guides.
y When you use more than one sheet of paper, fan the sheets well before placing them on the bypass tray. Be
careful not to cut your fingers when fanning them.
y Do not push paper into the entrance of the bypass feeder. This could cause a paper jam.
3
Press [CUSTOM PAPER] on the touch panel.
You can use non-standard size paper within the sizes shown on the right.
2
Place paper with its copy side down on the bypass
tray. Then align the side guides to the paper length
while holding a tab.
When paper is placed, the menu for bypass copying appears.
100
-
297 mm
(
3.9"
-
11.7"
)
148
-
432 mm
(
5.8"
-
17"
)