47
P48
Scheduled maintenance
This parameter allows to select the number of opening/closing cycles after which the message "SCHEDULED MAINTENANCE" appears
on the display of the program selector. The maintenance signal can also be displayed by the outputs OUT1 or OUT2 of the control unit
ET‑LOGIC‑B through the relay module UR24E if the operation mode G is selected in the functions F41M or F45m.
When set to OFF (default value), the scheduled maintenance message is never displayed.
Select the number of cycles after which maintenance is to be reported according to door operation and to the usage conditions:
8K (8,000 cycles), 16K (16,000 cycles), 32K (32,000 cycles), 64K (64,000 cycles), 128K (128,000 cycles), 256K (256,000 cycles), 512K
(512,000 cycles).
P49
Setting of the movable leaf total weight to meet the Low Energy motion requirements during opening (standard EN16005)
Selecting the value of the movable leaf total weight, the door opening speed will be automatically adjusted to meet the Low Energy movement
limits requirements of the standard EN16005.
The Low energy motion isn't generally protected by other safety devices, as the kinetic energy level is not regarded as dangerous; low energy
motion, however, is only considered for risk assessment purposes.
When the value is set to 00 Kg, the function is disabled and the opening speed depends on the value of the potentiometer P01; in this case the
installer must take other safety measures, in compliance with the regulations in force.
The setting values range for the total weight of the movable leaves is 30 Kg to 320Kg.
P50
Setting of the movable leaf total weight to meet the Low Energy motion requirements during closing (standard EN16005)
Selecting the value of the movable leaf total weight, door closing speed will be automatically adjusted to meet the Low Energy movement limits
requirements of the standard EN16005.
The Low energy motion isn't generally protected by other safety devices, as the kinetic energy level is not regarded as dangerous; low energy
motion, however, is only considered for risk assessment purposes.
When the value is set to 00 Kg the function is disabled and the closing speed depends on the value of the potentiometer P02; in this case the
installer must take other safety measures, in compliance with the regulations in force.
The setting values range for the total weight of the movable leaves is 30 Kg to 320Kg.
To Next Page
Loading...
Need help?
General
