Operation
CoaDATA 501 – Operators Manual 2.1 Page 21
By selecting:
- <ON> Cuvette detection occurs as soon as a cuvette is placed in the
measuring channel or removed from the measuring channel.
- <OFF> Cuvette detection occurs only when a cuvette is placed into
the measuring channel. The removal of cuvettes must be
confirmed by pressing the Reset-key.
• Select the desired cuvette detection.
• Press Enter-key to confirm entry.
<- select: ESC.
.. = work ENTER= more parameters
• Press Esc to access the measuring mode or Enter to add or verify
additional parameters.
To Next Page
Loading...