37
USER GUIDE
ELECTRIC SYSTEM ECOVIP KREOS
7.3 Power supply - Battery
charger
The battery charger can recharge different types of
batteries: for optimal battery charger operation, a
selector (d) is provided inside the charger that can be
accessed by removing the cover.
In case Lead-Acid batteries are used, set the selector
(d) in position “A”. In case Gel batteries are used, set
the selector (d) in position “B”. In case AGM batteries
are used, set the selector (d) in position “C”.
• Bear in mind that the battery capacity is limited
and lowers considerably in winter.
• Disconnect the battery poles in case of mainte-
nance works on the electric system.
• If your vehicle is not going to be in use for
a long time please disconnect the auxiliary
battery by means of the proper switch (see
below “ Battery master switch”).
THINGS TO DO
• Do not overload the lines with electric optional
equipment.
• Do not leave the engine turned on when either
the engine battery or the auxiliary battery
terminals are disconnected (danger of short
circuit).
THINGS TO AVOID
On the Ecovip series – except for DS models – the
power supply/battery charger is reached from the
outside through a door located on the left side
wall, front area. On the Ecovip DS models the
power supply/battery charger is installed inside
the settee behind the right cabin seat.
NOTE
Refer to the documentation provided by the
manufacturer of the battery to be installed to
make sure it is compatible with the battery
charger.
NOTE
If installing a second auxiliary battery or optional
equipment powered at 12 V, it is recommended to
install an additional power supply.
NOTE
d
On the Kreos series the power supply/battery
charger is reached from the garage, through a
door.
NOTE
To Next Page
Loading...
