USER GUIDE
66
HEATING SYSTEM
13.2.1 Ecovip A-class cab heating
In Ecovip A-class models with Alde heating system,
it is possible to turn on extra heating fans under the
cabin seats.
To activate the heating fans, press the switch located
on the base of the right cabin seat. You can select
two fan speeds: press part (a) for a higher speed or
part (b) for a lower speed. To turn off the heating fans,
place the switch in the middle position (“0”).
13.2.2 Heating of the rear bed area
(Kreos)
On the models of Kreos series there is a knob
present which permits an independent regulation of
the heating in the rear bed area, in confront to the rest
of the living area.
The Alde heating knob is located inside the rear
bedroom. By selecting the lowest value (*) you will
obtain the complete exclusion of the rear bed area
from the heating circuit, whilst raising the values,
the heating will increase in this area until complete
alignment with the rest of the living quarter (maxium
value).
13.2.3 Heating of the rear bed area
(Kosmo)
On the models of Kosmo series it is possible to
exclude the heating of the rear bed area by turning
valve (a). This valve is located inside the rear bedroom.
a
a
b