39
USER GUIDE
ELECTRIC SYSTEM ECOVIP KREOS
Internal temperature sensor
The internal temperature sensor is usually installed
next to the control panel or on the side of the piece of
furniture between the cab and the living quarters.
External temperature sensor
The external temperature sensor is below the floor in
the front right area of the vehicle.
Truma system temperature sensor
Sensor usually installed next to the control panel,
required for the operation of the Truma heating
system.
USB sockets
There are USB sockets in the living quarters that can
be used to charge devices such as smartphones. To
supply current to the USB sockets, activate the AUX
output on the control panel by means of the special
pushbutton (see chapter 9 - Control panel).
USB sockets integrated into the reading
lights
In the rear area there are USB sockets integrated
into the reading lights. To supply current to the USB
sockets, activate the 12 V/inside lights button on the
control panel.
Awning light
An awning light is fitted on the right-hand wall of the
vehicle. It can be turned on (only when the engine is
off) by means of the switch located on the control
panel.
To Next Page
Loading...
