Remote Operation
DFLT Factory Defaults Command
Input: DFLT 99[term]
Remarks: Sets all configuration values to factory defaults and resets
the instrument. The "99" is included to prevent accidentally
setting the unit to defaults.
DISPFLD Displayed Field Command
Input: DISPFLD <source>[term]
Format: n
<source> Specifies input data to display. Valid entries:
0 = kelvin, 1 = Celsius, 2 = sensor units, 3 =
Fahrenheit.
Example: DISPFLD 1[term] – Displays kelvin reading for the input.
DISPFLD? Displayed Field Query
Input: DISPFLD?[term]
Returned: <source>[term]
Format: n (Refer to command for description)
DISPON Display On/Off Command
Input: DISPON <state>[term]
Format: n
<state> 0 = Off, 1 = On
Remarks: Turns display On or Off. Display will default to On at
power up or if any key is pressed (even if the keypad is
locked).
DISPON? Display On/Off Query
Input: DISPON? [term]
Returned: <state> [term]
Format: n (Refer to command for description)
FRDG? Fahrenheit Reading Query
Input: FRDG?[term]
Returned: <temp value>[term]
Format: ±nnnnnn
Remarks: Also see the RDGST? command.
To Next Page
Loading...
