4 Technical Description
26
4.6.6 Menu function
[ change ] allows you to change parameter values. The sub-menu in the menu bar is
the same as the [ view ] menu.
But unlike this, the parameter to be changed is shown inverted (pale font on dark
background). Select the parameter using the cursor keys (up, down). Then press
[ENTER] to activate Edit (Change) mode. The parameter value flashes while it is
being edited.
A selected parameter is displayed in three ways:
Inverse display
→ Parameter can be changed
Bordered display
→ Parameter cannot be changed
Blinking display
→ Edit (Change) mode is active
You can now change the parameter value using the cursor keys (up, down, and left
and right for values with several characters). The functions in the menu bar are as
follows:
• [ esc ] returns to the [ change ] menu without confirming the
changed parameter.
• [ dflt ] resets the ‘default’ (factory-set) value.
• [ OK ] confirms the changed value and returns to the [ change ]
or [ENTER] menu.
This takes you back to the [ change ] menu. You can then open and change other
parameters.
To Next Page
Loading...
