Precautions
137
6
Printing after resetting the machine
After resetting the remote printer, the
connection from the print server will
be cut off for about 30-40 seconds be-
fore re-connecting. Depending on the
NetWare specification, print jobs may
be accepted, but they will not be
printed during this interval.
When using the machine as a remote
printer, wait about two minutes after
resetting before attempting to print.
When the optional IEEE 802.11b
interface unit Is Installed
When using the wireless LAN interface
on the network, note the following:
❖ When moving the machine
Detach the antennas when relocat-
ing the machine locally.
After moving the machine, reat-
tach the antennas, ensuring that:
• The antennas are positioned
clear of obstacles.
• There is 40 to 60 mm between
the antennas, so that they do not
touch.
• The exposure glass cover and the
Auto Document Feeder (ADF)
do not knock the antennas.
❖ If the network area provides poor ra-
dio environment
Where radio wave conditions are
bad, the network may not function
due to interrupted or failed con-
nections. When checking the wire-
less LAN signal and the access
point, follow the procedure below
to improve the situation:
• Position the access point nearer
to the machine.
• Clear the space between access
point and machine of obstruc-
tions.
• Move radio wave generating ap-
pliances, such as microwaves,
away from the machine and ac-
cess point.
Reference
For information about how to
check radio wave status, see p.12
“Checking the machine's radio
wave status”.
For more information about access
point radio wave conditions, refer
to the access point manual.
To Next Page
Loading...
