Lanier LD225 - Diprint; Dns

Monitoring and Configuring the Printer
90
4
❖ Domain name selection
msh> dhcp domainname {dhcp
| static}
• Specify whether to obtain the
domain name from the DNS
server or use the domain name
set by a user.
• To obtain the domain name from
the DHCP server, specify "dh-
cp". To use the domain name set
by a user, specify "static".
Reference
For details about DHCP functions,
see p.133 “Using DHCP”.
For details about setting the DNS
server address, see p.90 “dns”.
For details about setting the do-
main name, see p.91 “domain-
name”.
diprint
The direct printing port enables direct
printing from a network-connected
computer.
Use the “diprint” command to
change direct printing port settings.
❖ View settings
The following command displays
the current direct printing port set-
tings:
msh> diprint
Example output:
port 9100
timeout=300(sec)
bidirect on
conn multi
apl async
• The “port” specifies the port
number of the direct printing
port.
• The “bidirect” setting indicates
whether the direct printing port
is bidirectional or not.
❖ Setting timeout
msh> diprint timeout
[30~65535]
• You can specify the timeout in-
terval to use when the printer is
expecting data from the net-
work.
• The default is 300 seconds.
❖ Setting bidirect
msh> diprint bidirect { on
| off }
• You can specify whether the di-
rect printing port is bidirection-
al or not.
❖ Specifying the number of concurrent
connections
msh> diprint conn {multi |
single}
The above command specifies the
number of concurrent diprint con-
nections. Specify “multi” for mul-
tiple connections or “single” for a
single connection.
❖ Specifying synchronization
msh> diprint apl {async |
sync}
The above command specifies
whether to synchronize disconnec-
tion and application termination.
Specify “sync” if you want to per-
form synchronization, or “async”
otherwise.
dns
Use the “dns” command to configure
or display DNS (Domain Name Sys-
tem) settings.
❖ View settings
The following command displays
current DNS settings:
msh> dns