Using SmartDeviceMonitor for Admin
73
4
• Using Address Management
Tool, you can manage LAN-Fax
numbers, user names for Scan to
Folder, and addresses for send-
ing and receiving Internet faxes.
• The e-mail sender’s name and
folder can be protected.
Installing SmartDeviceMonitor
for Admin
Follow the procedure below to install
SmartDeviceMonitor for Admin
A Quit all applications currently
running.
B Insert the CD-ROM into the CD-
ROM drive.
The installer starts.
Note
❒ Auto Run may not work under
certain operating system set-
tings. In this case, launch “Set-
up.exe” located on the CD-
ROM root directory.
C Select an interface language, and
then click [OK].
The following languages are availa-
ble: Czech, Danish, German, Eng-
lish, Spanish, French, Italian,
Hungarian, Dutch, Norwegian,
Polish, Portuguese , Finnish, Swed-
ish, Chinese Simple and Chinese
Traditional.
D Click [SmartDeviceMonitor for Cli-
ent/Admin] installation, and then
click [Next >].
E The software license agreement
appears in the [License Agreement]
dialog box.
After reading through its contents,
click [I accept the agreement.] if you
agree, and then click [Next >].
F Follow the instructions on the
screen.
A message appears when the in-
stallation is complete.
G Click [OK].
Note
❒ If you are required to restart the
computer after installing Smart-
DeviceMonitor for Admin, re-
start the computer and continue
the configuration.
Changing the Network
Interface Board Configuration
Follow the procedure below to
change the network interface board
configuration using SmartDevice-
Monitor for Admin.
A Start SmartDeviceMonitor for Ad-
min.
B
On the
[
Group:
]
menu, point to
[
Search Device
]
, and then click
[
TCP/IP
]
,
[
IPX/SPX
]
or
[
TCP/IP(SNMPv3)
]
.
A list of machines using the selected
protocol appears.
Note
❒ Select the protocol of the ma-
chine whose configuration you
want to change.
❒ If you are using TCP/IP SNMP
V3, enter the user authentication.
C In the list, select a machine whose
configuration you want to
change.
To Next Page
Loading...
