Lanier LD225 - Btconfig; Devicename; Dhcp

Remote Maintenance by telnet
89
4
btconfig
Use the "btconfig" command to make
Bluetooth settings.
❖ View settings
Bluetooth settings are displayed.
msh> btconfig
❖ Mode settings
You can set the Bluetooth opera-
tion mode to {private} or {public}.
msh> btconfig {private |
public}
• The default is {public}.
devicename
Use the "devicename" command to
display and change the printer name.
❖ View settings
msh> devicename
❖ Printer name configuration
msh> devicename name
“string”
• Enter a printer name using up
to 31 alphanumeric characters.
• Set single names for each printer.
❖ Printer name initialization
msh> devicename clear name
• Reset the printer name to its de-
fault.
dhcp
Use the "dhcp" command to config-
ure DHCP settings.
❖ View settings
The following command displays
the current DHCP settings.
msh> dhcp
❖ Configuration
You can configure DHCP.
msh> dhcp “interface_name”
{on|off}
• Click {on} to enable dhcp. Click
{off} to disable DHCP.
• If the DNS server address and
domain name are obtained from
DHCP, be sure to click {on}.
• ip1394 can be specified only
when the IEEE 1394 interface is
installed.
• wlan can be specified only when
the IEEE 802.11b interface is in-
stalled.
❖ Current interface priority configura-
tion display
msh> dhcp priority
❖ Interface priority configuration
msh> dhcp priority
“interfac_name”
• You can select which interface
has DHCP parameter priority.
• Priority settings are available
when multiple interfaces are in-
stalled.
❖ DNS server address selection
msh> dhcp dnsaddr {dhcp |
static}
• Specify whether to obtain the
DNS server address from the
DHCP server or use the address
set by a user.
• To obtain the DNS server address
from the DHCP server, specify
"dhcp". To use the address set by
a user, specify "static".
Interface name Interface configured
ether Ethernet interface
ip1394 IEEE 1394 interface
wlan IEEE 802.11b interface