EasyManua.ls Logo

Lanier LD225 - Sending a Stored File

Lanier LD225
150 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Using a Printer Server
62
3
N Press the {Esc} key, and then click
[Yes] on the confirmation message.
O Press the {Esc} key to return to
[Print Server Configuration Menu].
P Assign print queues to the created
printer.
Q From [Print Server Configuration Menu],
select [Queues Serviced By Printer].
R Select the printer created.
S Press the {Insert} key to select a
queue serviced by the printer.
You can select several queues.
T Follow the instructions on the
screen to make other necessary
settings.
Following these steps, check that
the queues are assigned.
U Press the {Esc} key until "Exit?"
appears, and then select [Yes] to
exit PCONSOLE.
V Start the print server by entering
the following from the console of
the NetWare server.
If the print server is in operation,
quit and restart it.
To quit
CAREE: unload pserver
To start
CAREE: load pserver
print
_server_name
Note
If the printer works as config-
ured, the message "Waiting for
job" appears.
Setting Up as a Remote Printer
(NetWare 4.x, 5 / 5.1, 6 / 6.5)
Follow the procedure below to use
the printer as a remote printer under
NetWare 4.x, 5 / 5.1 and 6 / 6.5.
If TCP/IP and IP address is set, con-
figure using Web Image Monitor.
If IPX is set, configure using NIB Set-
up Tool.
Important
To use the printer as a remote print-
er under NetWare 4.x, 5 / 5.1, 6 / 6.5,
set it to NDS mode.
Do not use the printer as a remote
printer when Pure IP is used.
Setting up using NIB Setup Tool (TCP/IP)
A Log on to the file server as an ad-
ministrator or administrator
equivalent.
B Start NIB Setup Tool from the
[Start] menu.
C Click [Property Sheet], and then
click [OK].
D Select the printer you want to con-
figure, and then click [Finish ].
A dialog box prompting you to per-
form the remaining configuration
tasks in the Web browser appears.
Click [OK], and then wait until Web
Image Monitor starts automatically.
E A dialog box for entering the [User
Name] and [Password] appears.
Enter the user name and pass-
word, and then click [OK].
Note
For details about the password,
consult your network adminis-
trator.

Table of Contents

Other manuals for Lanier LD225

Related product manuals