Lanier LD225 - Page 67

Using NetWare
61
3
Setting up using NIB Setup Tool (IPX)
A Log on to the file server as a su-
pervisor or supervisor equivalent.
B Start NIB Setup Tool from [Start]
menu.
C Click [Property Sheet], and then
click [OK].
D Select a printer you want to con-
figure.
E On the [NetWare] tab, enter the
name of the print server in the
[Print Server Name:] box.
F In the [File Server Name:] box, enter
the name of the file server in
which a print server is created.
You can also click [Browse...] to
browse through available file serv-
ers.
G In the [Print Server Operation Mode]
area, click [As Remote Printer].
H In the [Remote Printer No.] box, en-
ter the printer number.
Use the same printer number cre-
ated in the print server.
I A confirmation message appears.
Click [OK].
J On the [NIB] menu, click [Exit].
Setting up using PCONSOLE
A Enter “PCONSOLE” from the com-
mand prompt.
F:> PCONSOLE
B Create a print queue.
When using the existing print
queue, go to the procedure for cre-
ating a printer.
C From the [Available Options] menu,
select [Print Queue Information], and
then press the {Enter} key.
D Press {Insert} key, and then enter a
print queue name.
E Press {Esc} key to return to the
[Available Options] menu.
F Set up the network connection to
a printer.
G On the [Available Options] menu,
click [Print Server Information], and
then press the {Enter} key.
H To create a new print server, press
the {Insert} key, and then enter a
print server name.
For a currently defined print serv-
er, select a print server in the [Print
Server] list.
Use the same printer name speci-
fied using NIB Setup Tool.
I From the [Print Server Information]
menu, select [Print Server Configura-
tion].
J From the [Print Server Configuration]
menu, select [Printer Configuration].
K Select the printer indicated as [Not
Installed].
Use the same printer number spec-
ified as the remote printer number
using NIB Setup Tool.
L To change the printer name, enter
a new name.
A name “printer x” is assigned to
the printer. The “x” stands for the
number of the selected printer.
M As type, select [Remote Parallel, LPT1].
The IRQ, Buffer size, Starting form,
and Queue service mode are auto-
matically configured.