Lanier LD225 - Two-Sided Printing

Monitoring and Configuring the Printer
92
4
❖ View settings
The following command displays
the current domain name:
msh> domainname
❖ Interface domain configuration
msh> domainname “inter-
face
_name”
❖ Setting the Domain Name
msh> domainname “inter-
face
_name” name “domain name”
• A domain name can be entered
using up to 63 alphanumeric
characters.
• The Ethernet interface and IEEE
802.11b interface will have the
same domain name.
• ip1394 can be specified only
when the IEEE 1394 interface is
installed.
• wlan can be specified only
when the IEEE 802.11b interface
is installed.
❖ Deleting the Domain Name
msh> domainname “inter-
face
_name” clear name
help
Use the "help" command to display the
available command list and the proce-
dures for using those commands.
❖ Command list display
msh> help
❖ Display of procedure for using commands
msh> help “command_name”
hostname
Use the “hostname” command to
change the printer name.
❖ View settings
msh> hostname
❖ Configuration
msh> hostname “interface_
name ” “printer_name”
• Enter the printer name using up
to 63 alphanumeric characters.
• You cannot use a printer name
starting with "RNP" or "rnp".
• The Ethernet interface and IEEE
802.11b interface will have the
same printer name.
• ip1394 can be specified only
when the IEEE 1394 interface is
installed.
• wlan can be specified only
when the IEEE 802.11b interface
is installed.
❖ Initializing the printer name for each
interface
msh>hostname
“interface_name” clear
name
ifconfig
Use the "ifconfig" command to con-
figure TCP/IP (IP address, subnet
mask, broadcast address, default
gateway address) for the printer.
Interface Interface set
ether Ethernet interface
ip1394 IEEE 1394 interface
wlan IEEE 802.11b interface
Interface name Interface configured
ether Ethernet interface
ip1394 IEEE 1394 interface
wlan IEEE 802.11b interface