Lanier LD225 - 5. Reception Features; Immediate Reception

Using SmartDeviceMonitor for Admin
77
4
D Enter the user code and user name.
E Select the check box of the func-
tions applicable to the new user.
Note
❒ If the check boxes are unavaila-
ble, there is no restriction to use
that function. For details, see
SmartDeviceMonitor for Ad-
min Help.
F Click [OK].
The new user is added.
G On the [Edit] menu, click [Apply
Settings].
The settings are applied.
H Click [Exit] on the [File] menu to
quit User Management Tool.
Reference
For details about setting restric-
tions, see SmartDeviceMonitor
for Admin Help.
Configuring the Energy Saver Mode
Follow the procedure below to con-
figure Energy Saver mode.
A Start SmartDeviceMonitor for Ad-
min.
B On the [Group:] menu, point to
[Search Device], and then click
[TCP/IP], [IPX/SPX] or [TCP/IP
(SNMPv3)].
A list of machines using the select-
ed protocol appears.
Note
❒ Select the protocol of the ma-
chine whose configuration you
want to change.
❒ If you are using TCP/IP SNMP
V3, enter the user authentication.
C Select the machine whose settings
you want to make.
To make settings for all machines
in the selected group, select no ma-
chine.
D On the [Group:] menu, point to [En-
ergy Saver Mode], point to [Set Individ-
ually] to make the settings for only
the selected machine or point to
[Set By Group] to make the settings
for all machines in the selected
group, and then click [On] or [Off].
E Quit SmartDeviceMonitor for
Admin.
Reference
For details about the setting val-
ue for Energy Saver mode, see
SmartDeviceMonitor for Ad-
min Help.
Setting a Password
Follow the procedure below to set a
password.
A Start SmartDeviceMonitor for Ad-
min.
B On the [Group:] menu, point to
[Search Device], and then click
[TCP/IP], [IPX/SPX] or [TCP/IP
(SNMPv3)].
A list of machines using the select-
ed protocol appears.
Note
❒ Select the protocol of the ma-
chine whose configuration you
want to change.
❒ If you are using TCP/IP SNMP
V3, enter the user authentication.
C In the list, select a machine whose
configuration you want to
change.