Setting Up the Machine on a Network
35
2
Limitation
❒ Enter a [Scope ID] using up to 31
alphanumeric characters.
Note
❒ Default: Off
❖ Effective Protocol
Select the protocol to use in the
network.
• TCP/IP:Effective/Invalid
• NetWare:Effective/Invalid
• SMB:Effective/Invalid
• AppleTalk:Effective/Invalid
Note
❒ Default: TCP/IP: Effective, Net-
Ware: Effective, SMB: Effective,
AppleTalk: Effective
❖ NCP Delivery Protocol
Select the protocol for NCP delivery:
•IPX Priority
• TCP / IP Priority
•IPX Only
• TCP / IP Only
❖ NW Frame Type
Select the frame type when you
use NetWare.
•Auto Select
•Ethernet II
• Ethernet 802.2
• Ethernet 802.3
• Ethernet SNAP
Note
❒ Default: Auto Select
❖ SMB Computer Name
Specify the SMB computer name.
❖ SMB Work Group
Specify the SMB work group.
❖ Ethernet Speed
Set the access speed for networks.
Select a speed that matches your
network environment. [Auto Select]
should usually be selected.
•Auto Select
• 100Mbps Full Duplex
• 100Mbps Half Duplex
• 10Mbps Full Duplex
•10Mbps Half Duplex
Note
❒ Default: Auto Select
❖ LAN Type
When you have installed the op-
tional IEEE 802.11b interface unit,
select interface, IEEE 802.11b (wire-
less LAN) or Ethernet.
•Ethernet
• IEEE 802.11b
Note
❒ Default: Ethernet
❒ Appears when the optional IEEE
802.11b interface unit is installed.
❒ If Ethernet and IEEE 802.11b
(wireless LAN) are both connect-
ed to the machine, the selected
interface takes precedence.
❖ Ping Command
Check the network connection with
ping command using given IP address.
Note
❒ If you fail to connect to the net-
work, check the following, and
then retry the ping command.
• Check TCP/IP of the printer
is active.
• Check that the machine with
assigned IP address is con-
nected to the network.
• There is a possibility that same
IP address is used for the spec-
ified equipment.
❖ Permit SNMP V3 Communication
Set the encrypted communication
of SNMP v3.
•Encryption Only
• Encryption / Clear Text
Note
❒ If you set to [Encryption Only],
you need to set password for
the machine.
To Next Page
