Setting Up the Machine on a Network
37
2
❖ IP over 1394
When you use the IP over 1394
function of the IEEE 1394 interface
to connect the machine to the net-
work, or you print from computer
with the IP over 1394 driver, you
must specify [Active]for [IP over
1394].
•Active
•Inactive
Limitation
❒ Printing with IP over 1394 is pos-
sible under Windows Me/XP
and Windows Server 2003
Note
❒ Default: Active
❖ SCSI print (SBP-2)
When you print using the SCSI
print client function supported by
Windows 2000/XP, or Windows
Server 2003, you must set [SCSI
print (SBP-2)].
•Active
•Inactive
Limitation
❒ The IEEE 1394 interface can be
used when Windows 2000 Serv-
ice Pack 1 or later is installed. If
the Service Pack is not installed,
only one SCSI print device is
connectable via 1394 bus.
Note
❒ Default: Active
❖ Bidirectional SCSI print
Specifies the printer's response
mode etc. for status requests when
using the IEEE 1394 interface.
•On
•Off
Note
❒ Default: On
❒ If this is set to [Off], bidirectional
communication will not work.
IEEE 802.11b
Preparation
You must install the optional IEEE
802.11b interface unit into the ma-
chine.
Note
❒ Be sure to make all settings simul-
taneously.
To Next Page
