Using a Printer Server
54
3
B Start NIB Setup Tool from the
[Start] menu.
C Click [Wizard], and then click [OK].
D Select the printer you want to con-
figure, and then click [Finish ].
A dialog box prompting you to
perform the remaining configura-
tion tasks in the Web browser ap-
pears. Click [OK], and then wait
until Web Image Monitor starts au-
tomatically.
E A dialog box for entering the [User
Name] and [Password] appears.
Enter the user name and pass-
word, and then click [OK].
Note
❒ For details about the password,
consult your network adminis-
trator.
F Click [Configuration] in the left ar-
ea, click [Network], and then click
[NetWare].
• Print Server Name: Enter the Net-
Ware print server name. To use
the interface board as a print
server, enter the name of a print
server that is not active on the file
server. Use up to 47 characters.
• Logon Mode: Specify whether to
designate a file server or NDS
tree when logging on to Net-
Ware.
• File Server Name: When a file
server name is entered here,
only the specified file server is
searched for. This item is man-
datory. Use up to 47 characters.
• NDS Tree: To enable NDS mode,
enter the name of the NDS tree
you want to log on to. Use up to
32 alphanumeric characters.
• NDS Context Name: To enable
NDS mode, enter the print server
context. Use up to 127 characters.
• Operation mode: Specify wheth-
er to use the interface board as a
print server or a remote printer.
• Remote printer number: This
item is effective when the inter-
face board is specified as a re-
mote printer. Enter the same
number as the number of the
printer to be created on the print
server (0 to 254 characters).
• Job Timeout: When the interface
board is used as a NetWare remote
printer, the printer cannot detect
when a print job ends. Therefore,
the printer terminates printing
when a certain period of time has
elapsed since it last received print
data (i.e., when it has not received
print data for a certain period of
time). Specify here this period of
time (3 to 255 seconds). The initial
value is 15 (seconds).
• Frame Type: Select the frame
type from the drop-down menu.
• Print Server Protocol: Select the
protocol for NetWare from the
drop-down menu.
• NCP Delivery Protocol: Select
the protocol for NCP delivery.
G Confirm the settings, and then
click [Apply].
Configuration is now complete.
Wait several before restarting Web
Image Monitor.
Note
❒ To check the configuration is
correct, enter the following
from the command prompt:
F:> USERLIST
❒ If the printer works as config-
ured, the name of the print serv-
er appears as a connected user.
To Next Page
Loading...
