Lattice Semiconductor MachXO2 User Manual

MachXO2 and MachXO3 Starter Kit Evaluation Board User Guide
Evaluation Board User Guide
© 2014-2022 Lattice Semiconductor Corp. All Lattice trademarks, registered trademarks, patents, and disclaimers are as listed at www.latticesemi.com/legal.
All other brand or product names are trademarks or registered trademarks of their respective holders. The specifications and information herein are subject to change without notice.
2 FPGA-EB-02036-1.4
Disclaimers
Lattice makes no warranty, representation, or guarantee regarding the accuracy of information contained in this document or the suitability of its
products for any particular purpose. All information herein is provided AS IS, with all faults and associated risk the responsibility entirely of the Buyer.
Buyer shall not rely on any data and performance specifications or parameters provided herein. Products sold by Lattice have been subject to limited
testing and it is the Buyer's responsibility to independently determine the suitability of any products and to test and verify the same. No Lattice
products should be used in conjunction with mission- or safety-critical or any other application in which the failure of Lattice’s product could create a
situation where personal injury, death, severe property or environmental damage may occur. The information provided in this document is
proprietary to Lattice Semiconductor, and Lattice reserves the right to make any changes to the information in this document or to any products at
any time without notice.

Lattice Semiconductor MachXO2 Specifications

General

Family	MachXO2
Manufacturer	Lattice Semiconductor
User Flash Memory (UFM)	Up to 256 Kbits
Device Type	FPGA
Technology	FPGA
Embedded Memory	Up to 240 Kbits
Number of I/Os	Up to 335
I/O Standards	LVCMOS, LVTTL, PCI, LVDS, Bus-LVDS, MLVDS
Operating Voltage	1.2V to 3.3V
Package Options	QFN, TQFP, BGA
On-Chip PLLs	1 or 2
Operating Temperature Range	-40°C to 100°C
Configuration	JTAG

Summary

Introduction

Features

Storage Handling

Software Requirements

MachXO2 and MachXO3 Devices

Demonstration Design

Overview

Overview of the starter kit's capabilities and components.

Run Demonstration Design

Step-by-step guide to run the pre-programmed demo design.

Download Demo Designs

Instructions for downloading and obtaining demo design files.

Program Demo Design with Lattice Diamond

Guide for programming the FPGA with custom or demo designs.

MachXO2 and MachXO3 Starter Kits

Key System Components and Features

Details subsystems like FPGAs, clocks, interfaces, LEDs, power, and test points.

Board Modifications and Specifications

Information on board modifications, power measurement, mechanical and environmental specs.

Troubleshooting

Common Issues and Solutions

Diagnosing and resolving common problems like LED, USB, and driver issues.

Restore Original Demo Design

Instructions to restore the board to its factory default demo.

Ordering Information

Technical Support Assistance

Appendix A. Schematic Diagrams

Appendix B. Bill of Materials

Revision History