LAUNCH
X-431 PRO5 User Manual
iii
The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common sense and caution
are factors which cannot be built into this product, but must be supplied by the operator.
There are no user serviceable parts. Have the tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the equipment is maintained.
Please use the included battery and charger. Risk of explosion if the battery is replaced with an incorrect type.
Automotive batteries contain sulfuric acid that is harmful to skin. In operation, direct contact with the automotive
batteries should be avoided. Keep the ignition sources away from the battery at all times.
Precautions on Operating Vehicle’s ECU
Do not disconnect battery or any wiring cables in the vehicle when the ignition switch is on, as this could avoid
damage to the sensors or the ECU.
Do not place any magnetic objects near the ECU. Disconnect the power supply to the ECU before performing
any welding operations on the vehicle.
Use extreme caution when performing any operations near the ECU or sensors. Ground yourself when you
disassemble PROM, otherwise ECU and sensors can be damaged by static electricity.
When reconnecting the ECU harness connector, be sure it is attached firmly, otherwise electronic elements,
such as ICs inside the ECU, can be damaged.
To Next Page
Loading...
