LAUNCH
X-431 PRO5 User Manual
62
11 Videoscope
11.1 Introduction
Automotive videoscope is mainly applied to those unseen parts of engine, fuel tank, braking system.
While testing a vehicle system, engine is one of the main parts to be checked. To check if the internal of an engine
is qualified or not or whether internal carbon deposit and damage exists in the engine or not, we can make full use
of a videoscope to solve these questions.
This tool provides an optional function of videoscope (needs to be purchased separately).
The videoscope is mainly composed of an inspection camera, flexible tube and data cable. The water-resistant
camera lens with adjustable LED lights enables you to observe the parts that cannot be seen in wet, dark, fluid
soaked places. The included flexible tube is convenient for easy inspection and allows for access to hard-to-reach
areas.
In addition, the captured pictures and videos also provide you intuitive data for easy analysis.
11.2 Connections & Operations
1. Insert the data cable of the videoscope into the charging/data I/O port of port of the tablet.
2. Bend the neck of the flexible tube as desired and extend the camera with adjustable LED lights to some unseen
or unreachable parts of engine, hydraulic system, nozzles etc.
3. After connections are properly made and turn the tablet on. Go to Others -> Videoscope to run it, then the
screen will display the scene captured from the videoscope camera.
5. Adjust it until the lens stops in the desired place and then use the dial for LED light brightness to adjust the
brightness.
6. Press the Snapshot button on the videoscope to take a photo. Alternatively, you can also press the Snapshot
button on the tablet to take photos.
To record a video, switch from Camera mode to Video mode and tap the Record button on the screen to start
recording.
Images are captured in .jpg format and videos are recorded in .avi or .mp4 format. All photographings and videos
are saved in DCIM folder where users can browse and replay it.
To Next Page
Loading...
