LELY POLYMAT 300W - Uncoupling of the Combination; Uncoupling of the POLYMAT from the Tractor

- Stop the tractor engine. Dismount the PTO shaft from the
LELYTERRA’s PTO extension. Place the PTO shaft in the
holder on the LH chassis tube (fig. 37).
- Unlock the catch hooks A (fig. 37) of the lower linkage
points.
- Lower the LELYTERRA until it is clear of the POLYMAT
and drive forwards.
- Fit the rubber gasket disc in the protection cap of the
LELYTERRA’s PTO extension (fig. 38).
8.2
Uncoupling of the combination
(continued from “Dismounting”)
- Place the combination on the ground.
- Dismount the tractor top link from the LELYTERRA.
- Stop the tractor engine. Remove the PTO shaft from the
tractor PTO.
- Place the PTO shaft in the holder on the headstock.
- Dismount the tractor lower link arms from the LELY-
TERRA.
8.3
Uncoupling of the POLYMAT from
the tractor
(continued from “Dismounting”)
- Dismount the top link from the POLYMAT.
- Lift the POLYMAT carefully until the parking jacks can be
slid into the frame.
- Slide the parking jacks into the frame and secure them with
lynch pins.
- Lower the POLYMAT until the parking jacks are on the
ground.
- Stop the tractor engine. Remove the PTO shaft from the
tractor PTO.
- Place the PTO shaft in the holder A (fig. 39) on the LH
coupling piece.
- Dismount the tractor lower link arms from the POLYMAT.
57
37
38
39
A
A