LEM DX 24 - Input Ganging; Output Ganging

39
So generally speaking, to avoid contradictions, oversights and confusion between what is shown and what is effectively
carried out,
it’s advisable to enable the Ganging functions before starting to edit a PRESET. Moreover, it’s best to
make certain to effectively set the required value, manually confirming all the parameters required.
N.B.: the elements in Ganging assume the “new” value as soon as the DIAL changes the status of the “old” value.
So, if the value which has to be allocated to the elements in Ganging is the same as the “old” value, it’s necessary to
use the DIAL, temporarily change the value (even only by one step) and then go back to the “old” value.
Input Ganging
Allows to enable/disable Ganging function on the inputs.
The settings are:
Disabled Enabled
In
p
ut Gan
g
in
g
Off
In
p
ut Gan
g
in
g
On
Output Ganging
Allows to enable/disable Ganging function on the outputs.
The settings are:
Disabled Enabled
Out
p
ut Gan
g
in
g
Off
Out
p
ut Gan
g
in
g
On
UTILITY menu