LEMKEN Karat 9 - Specific Safety Instructions

83 pages

Save Page as PDF

To Next Page

To Previous Page

Safety measures and precautions

ATTENTION: Do not remain in the operating and

swivel area of the device!

ATTENTION: Danger of crushing!

Main Page

Table of Contents5
Contents5
General Information10
Liability10
Guarantee10
Copyright11
Optional Accessories11
Symbols Used in the Operating Instructions12
Hazard Classes12
Information12
Environmental Protection12
Indication of Passages13
Safety Measures and Precautions14
Target Group14
Intended Use14
Safety Equipment on the Device15
Safety and Warning Signs16
General Information16
Meaning of Warning Signs16
Position of the Safety and Warning Signs18
Special Safety Instructions19
Hazardous Areas21
Hazardous Areas During Operation of the Device21
Residual Risks21
Hazard Caused by Mechanical Systems22
Hazard Caused by Hydraulic Systems22
Hazard During Operation22
Applicable Rules and Regulations22
Operation on Public Highways23
Lighting System and Identification23
Requirements of the Tractor23
Axle Loads24
Check before Departure25
Correct Behaviour in Road Traffic25
Obligation of the Operator26
Operating the Device Safely27
General Information27
Personnel Selection and Qualifications28
Handing over the Device29
Design and Function30
Overview30
Function31
Three-Point Headstock31
Frame31
Tines32
Working Depth Adjustment of the Tines32
Automatic Overload Safety Device for the Tines32
Hollow Discs33
Edge Discs33
Rollers33
Preparation of the Tractor34
Tyres34
Lift Rods34
Check Chains or Sway Blocks of the Three Point Linkage34
Required Power Sources34
Required Hydraulic Equipment35
Three-Point Linkage36
Hydraulic System38
Transport38
Work Assignment38
Coupling and Uncoupling38
Coupling and Uncoupling39
Coupling39
Uncoupling43
Draw Rail44
Mounting Position44
Changing the Mounting Position45
Top Link46
Mounting Position46
Changing the Mounting Position47
Safety Equipment48
General Information48
Warning Sign with Light48
Transport Dimensions48
Adjustments49
Working Depth of Tines50
General Information50
Hydraulic Working Depth Adjustment51
Lowering Depth of the Rollers51
Support Wheels52
Working Depth of the Hollow Discs54
Working Depth of the Edge Discs55
Share Position56
Automatic Overload Protection58
Tine58
Hollow Discs58
Edge Discs59
Rollers60
General Information60
Blade Rollers61
Pressure Load on Rollers63
Switching over to Different Share Systems65
Share Tips, Guide Plates and Wing Shares65
Tine with Integrated Share Foot66
Tine with Quick-Change System67
Removing the Share Foot67
Attaching the Share Foot69
Switching off the Device71
Shutting down the Device in an Emergency71
Disposal71
Maintenance and Repairs72
Special Safety Instructions72
General72
Personnel Qualifications72
Protective Clothing72
Shutting down the Device for Maintenance and Repairs73
Working on the Hydraulics73
Working on the Electrics73
Working under the Raised Device74
Utilised Tool74
Environmental Protection75
Maintenance Intervals76
After the Initial Start-Up (at the Latest after 2 Hours)76
Daily Inspection76
Weekly Inspection77
Tightening Torques78
Wheel Nuts78
Other Screw Connections78
Checking Connections to the Tractor79
Tyres and Air Pressure80
Identification Plate81
Noise, Airborne Sound82
Notes82
Index83

LEMKEN Karat 9 - Specific Safety Instructions

Table of Contents

Related product manuals