Switching over to different share systems
65
10.3 Tine with quick-change system
If the tine (1) features a quick-change system with exchangeable share foot (2),
the share foot (2) can be removed together with the share system after the linch
pin (3) has been removed and replaced by a share foot (2) with a different share
system. In this way the device can be switched over to a different soil processing
method within a few minutes.
10.3.1 Removing the share foot
Switch the tractor hydraulics to position
control.
Lift the device out all the way.
Secure the device with a support to pre-
vent it from unintentionally dropping.
Lock the control units of the tractor and
switch the tractor engine off.
Using the LEMKEN hook wrench (4),
swivel the retaining wire (5) of the linch
pin (3) backwards.
Hold the share foot (2) in the detent po-
sition by pressing the guide plate (5)
against the tine (1).
Remove the linch pin (3) by pulling it
upwards.
2
4
3
1
5
1
3
5
4
To Next Page
Loading...
