Design and function
30
5.4 Tines
Either tines with a permanently integrated share foot or tines with quick-change
system can be used.
a) Tines with permanently integrated share foot
On this tine the different share tips, guide plates and wing shares can be screwed
on and off independently of each other.
b) Tines with quick-change system
Share feet with different share systems can be attached to these tines and se-
cured by linch pins.
5.4.1 Working depth adjustment of the tines
The working depth must be adjusted separately for the left and right sides of the
device. This is done using an adjustment mechanism with pins.
5.4.2 Automatic overload safety device for the tines
The automatic overload safety device for the tines protects the frame and the tines
from overload. The spring of the overload safety device has been preset. This set-
ting must not be changed. The reset force on the share tip is 5500 N and the acti-
vation height 200 mm.
To Next Page
Loading...
