LEMKEN Karat 9 - Page 8

Contents
6
9.8.1 General information..................................................................................................58
9.8.2 Blade rollers............................................................................................................. 59
9.9 Pressure load on rollers .............................................................................................61
10 Switching over to different share systems...........................................................63
10.1 Share tips, guide plates and wing shares.................................................................63
10.2 Tine with integrated share foot ..................................................................................64
10.3 Tine with quick-change system ................................................................................. 65
10.3.1 Removing the share foot.......................................................................................65
10.3.2 Attaching the share foot........................................................................................ 67
11 Switching off the device.........................................................................................69
11.1 Shutting down the device in an emergency.............................................................. 69
11.2 Disposal .......................................................................................................................69
12 Maintenance and repairs........................................................................................70
12.1 Special safety instructions.........................................................................................70
12.1.1 General................................................................................................................. 70
12.1.2 Personnel qualifications........................................................................................70
12.1.3 Protective clothing ................................................................................................70
12.1.4 Shutting down the device for maintenance and repairs........................................71
12.1.5 Working on the hydraulics .................................................................................... 71
12.1.6 Working on the electrics .......................................................................................71
12.1.7 Working under the raised device ..........................................................................72
12.1.8 Utilised tool...........................................................................................................72
12.2 Environmental protection...........................................................................................73
12.3 Maintenance intervals.................................................................................................74
12.3.1 After the initial start-up (at the latest after 2 hours)...............................................74
12.3.2 Daily inspection ....................................................................................................74
12.3.3 Weekly inspection.................................................................................................75
12.4 Tightening torques...................................................................................................... 76
12.4.1 Wheel nuts............................................................................................................ 76
12.4.2 Other screw connections......................................................................................76
12.5 Checking connections to the tractor......................................................................... 77